|
|
|
 |
| |
Electrical Characteristics
| |
|
|
MIN |
TYP |
MAX |
UNIT |
| Frequency Response |
ST OUT |
GAIN: min (CH 1-2, CH 3/4-5/6)
20Hz-20kHz, refer to the nominal output level @1kHz |
-3.0 |
|
1.0 |
dB |
| AUX SEND (EFFECT SEND*) |
-3.0 |
|
1.0 |
| MONITOR OUT, REC OUT |
-3.0 |
|
1.0 |
| Total Harmonic Distortion(THD+N) |
ST OUT |
+14dBu, 20Hz-20kHz, Input Gain control at minimum |
|
|
0.1 |
% |
Hum and Noise
Hum and Noise are measured with a 6dB/octave filter @12.7kHz; equivalent to a 20kHz filter with infinite dB/octave attenuation.
|
input: CH INPUT 1-2 MIC |
EIN (Equivalent Input Noise): Rs=150Ω, GAIN:max (CH1,2) |
|
|
-128 |
dBu |
| ST OUT |
ST MASTER CONTROL at nominal level
and all Ch level controls at minimum. |
|
|
-87 |
dBu |
| AUX SEND (EFFECT SEND*) |
All Ch AUX controls at minimum |
|
|
-85 |
dBu |
| ST OUT |
ST Master Control and one CH level control at nominal level (CH1,2) |
|
|
-64 |
dBu |
| ST OUT |
Residual Output Noise |
|
|
-100 |
dBu |
| Crosstalk (1kHz) |
Adjacent Input |
CH 1-2, 1kHz |
|
|
-70 |
dB |
| Input to Output |
STEREO L/R, CH 1, 2, PAN: Hard left or right, 1kHz |
|
|
-70 |
dB |
Maximum Voltage Gain (1kHz)
All VR are MAX when measured.
PAN/BAL: panned hard left or hard right
|
Rs=150Ω,
INPUT GAIN: max |
MIC to CH INSERT OUT |
|
60 |
|
dB |
| MIC to ST OUT |
|
76 |
|
dB |
| MIC to REC OUT |
|
58.2 |
|
dB |
| MIC to MONITOR OUT |
|
92 |
|
dB |
| MIC to PHONES OUT |
|
81 |
|
dB |
| MIC to AUX SEND (EFFECT SEND*) |
|
76 |
|
dB |
| LINE to ST OUT |
|
50 |
|
dB |
| LINE to AUX SEND (EFFECT SEND*) |
|
47 |
|
dB |
| ST CH 7/8- (9/10**) to ST OUT |
|
26 |
|
dB |
| Rs=150Ω |
RETURN to ST OUT |
|
12 |
|
dB |
| Rs=600Ω |
2TR IN to ST OUT |
|
23.8 |
|
dB |
| Phantom Voltage |
MIC |
|
|
48 |
|
V |
| Input HPF |
|
CH 1-2 and CH 3/4-5/6, 80Hz, 12dB/oct |
Input Equalization
Turn over/ roll-off frequency of shelving: 3dB blow maximum variable level, +15,-15 dB maximum |
CH 1-2 and CH 3/4-5/6 |
HIGH: 10kHz: shelving |
| MID: 2.5kHz: peaking |
| LOW: 100Hz: shelving |
| CH 7/8-(9/10**) |
HIGH: 10kHz: shelving |
| LOW: 100Hz: shelving |
| Internal Digital Effect* |
|
16 prgrams, PARAMETER cotrol , Foot Switch (effect on/off) |
| LED Level Meter |
Pre MONITOR leve |
2x7 point LED meter (PEAK,+6,+3,0,-5,-10,-20 dB)
PEAK lights if the signal comes within 3 dB of the clipping level. |
| Power Supply Adaptor |
PA-10 |
AC 38VCT, 0.62A, Cable Length=3.6m |
| Power Consumption |
|
21 W |
Dimensions
(WxHxD) |
|
256.6mm x 62.2mm x 302.5mm |
| Net Weight |
|
1.6 kg (MG82CX), 1.5 kg (MG102C) |
| Option |
|
Microphone Stand Adaptor (BMS-10A), Foot Switch* (FC5) |
All VR are nominal when measured. (Nominal position is adjusted to a position that is 6dB lower than the MAX position) Output impedance of signal generator:150ohms
*: EFFECT exists only in MG82CX
**: ST CH IN 9/10 exists only in MG102C
Input specifications
| Input Terminals |
GAIN |
Actual Load Impedance |
For Use with Nominal |
Input Level |
Connector |
| Sensitivitiy *2 |
Nominal |
Max. before clip |
| CH IN MIC (1-2) |
-60dB |
3kΩ |
50-600Ω Mics |
-72dBu(0.195mV) |
-60dBu(0.775mV) |
-40dBu(7.75mV) |
XLR-3-31 type *3 |
| -16dB |
-28dBu (30.8mV) |
-16dBu (123mV) |
+4dBu (1.23V) |
| CH IN LINE (1-2) |
-34dB |
10kΩ |
600Ω Lines |
-46dBu (3.88mV) |
-34dBu (15.5mV) |
-14dBu (155mV) |
Phone Jack (TRS) *4 |
| +10dB |
- 2dBu (0.615V) |
+10dBu (2.45V) |
+30dBu (24.5V) |
ST CH MIC IN
(3/4, 5/6) |
-60dB |
3kΩ |
50-600Ω Mics |
-72dBu(0.195mV) |
-60dBu(0.775mV) |
-40dBu(7.75mV) |
XLR-3-31 type *3 |
| -16dB |
-28dBu (30.8mV) |
-16dBu (123mV) |
-6dBu (389mV) |
ST CH LINE IN
(3/4, 5/6) |
-34dB |
10kΩ |
600Ω Lines |
-46dBu (3.88mV) |
-34dBu (15.5mV) |
-14dBu (155mV) |
Phone Jack *5 |
| +10dB |
- 2dBu (0.615V) |
+10dBu (2.45V) |
+30dBu (24.5V) |
| ST CH IN (7/8, 9/10 *7) |
- |
10kΩ |
600Ω Lines |
-22dBu (61.5mV) |
-10dBu (245mV) |
+10dBu (2.45V) |
Phone Jack *5
RCA PiN Jack |
| CH INSERT IN (1-2) |
- |
10kΩ |
600Ω Lines |
-12dBu (195mV) |
0dBu (0.775V) |
+20dBu(7.75V) |
Phone Jack (TRS) *6 |
| RETURN [L,R] |
- |
10kΩ |
600Ω Lines |
- 8dBu (308mV) |
+4dBu (1.23 V) |
+24dBu(12.3V) |
Phone Jack *5 |
| 2TR IN [L,R] |
- |
10kΩ |
600Ω Lines |
-22dBV (79.4mV) |
-10dBV (0.316V) |
+10dBV(3.16V) |
RCA Pin Jack |
*1 0dBu is referenced to 0.775Vrms. 0dBV is referenced to 1Vrms.
*2 Sensitivity is the lowest level that will produce an output of +4dB(1.23V), or the nominal output level when the unit is set to maximum level.(all faders and level controls are at maximum position.)
*3 XLR-3-31 type connectors are balanced.(1=GND, 2=HOT, 3=COLD)
*4 Phone jacks are balanced.(Tip=HOT, Ring=COLD, Sleeve=GND)
*5 Phone Jacks are unbalanced.
*6 Phone Jacks are unbalanced.(Tip=Out, Ring=In, Sleeve=GND)
*7 ST CH IN 9/10 exists only in MG102C
Output specifications
| Output Terminals |
Actual Source Impedance |
For Use with Nominal |
Output Level |
Connector |
| Nominal |
Max.Before Clip |
| STEREO OUT [L,R] |
150Ω |
10KΩ Lines |
+4dBu (1.23 V) |
+20dBu(7.75V) |
Phone Jack *2 |
AUX SEND
(EFFECT SEND *4) |
150Ω |
10KΩ Lines |
+4dBu (1.23 V) |
+20dBu(7.75V) |
Phone Jack *2 |
| CH INSERT OUT (1-2) |
75Ω |
10KΩ Lines |
0dBu (0.775V) |
+20dBu(7.75V) |
Phone Jack *3 |
| REC OUT [L, R] |
600Ω |
10KΩ Lines |
-10dBV (0.316V) |
+10dBV(3.16V) |
RCA Pin Jack |
| MONITOR OUT [L, R] |
150Ω |
10KΩ Lines |
+4dBu (1.23 V) |
+20dBu(7.75V) |
Phone Jack *2 |
| PHONES OUT |
100Ω |
40KΩ Lines |
3mW |
75mW |
Stereo Phone Jack |
*1 0dBu is referenced to 0.775Vrms. 0dBV is referenced to 1Vrms.
*2 Phone jacks are impedance balanced.(Tip=HOT,Ring=COLD,Sleeve=GND)
*3 Phone Jacks are unbalanced.(Tip=Out, Ring=In, Sleeve=GND)
*4 EFFECT SEND exists only in MG82CX
|
|
|