|
|
|
 |
| |
General specifications
| Internal processing |
32bit (Accumulator 58bit) |
| Number of scene memories |
99 |
| Sampling frequency |
Internal |
44.1kHz, 48kHz, 88.2kHz, 96kHz |
| External |
Normal rate: 44.1kHz-10% - 48kHz+6%
Double rate: 88.2kHz-10% - 96kHz+6% |
| Signal delay |
Less than 1.6ms CH INPUT to STEREO OUT
(@Sampling frequency = 48kHz)
Less than 0.8ms CH INPUT to STEREO OUT
(@Sampling frequency = 96kHz) |
| Fader resolution |
100mm motorized x17 |
Total harmonic distortion *
Input GAIN=Min. |
CH INPUT to STEREO OUT
Less than 0.05%, 20Hz to 20kHz @+14dB into 600ohms
Less than 0.01%, 1kHz @+24dB into 600ohms
(@Sampling frequency = 48kHz)
Less than 0.05%, 20Hz to 40kHz @+14dB into 600ohms
Less than 0.01%, 1kHz @+24dB into 600ohms
(@Sampling frequency = 96kHz) |
| Frequency response |
CH INPUT to STEREO OUT
0.5, -1.5dB, 20Hz - 20kHz @+4dB into 600ohms
(@Sampling frequency = 48kHz)
0.5, -1.5dB, 20Hz - 40kHz @+4dB into 600ohms
(@Sampling frequency = 96kHz) |
Dynamic range
(maximum level to noise level) |
110dB typ. DA Converter (STEREO OUT)
106dB typ. AD+DA (to STEREO OUT) @fs=48kHz
106dB typ. AD+DA (to STEREO OUT) @fs=96kHz |
Hum & noise level **
(20Hz-20kHz)
Rs=150ohms
Input GAIN=Max
Input PAD=0dB
Input PAD=0dB
Input sensitivity=-60dB |
-128dB Equivalent Input Noise.
-86dB residual output noise. STEREO OUT
STEREO OUT off.
-86dB (90dB S/N)STEREO OUT
STEREO fader at nominal level and all CH INPUT faders at minimum level.
-64dB (68dB S/N) STEREO OUT
STEREO fader at nominal level andone CH INPUT fader at nominal level |
| Maximum voltage gain |
74dB CH INPUT (CH1-12) to STEREO OUT/OMNI (BUS) OUT
40dB CH INPUT (CH13-16) to STEREO OUT
74dB CH INPUT (CH1-12) to OMNI (AUX) OUT (via pre input fader)
74dB CH INPUT (CH1-12) to MONITOR OUT (via STEREO BUS) |
Crosstalk(@1kHz)
Input GAIN=min |
80dB adjacent input channels (CH1-12)
80dB adjacent input channels (CH13-16)
80dB input to output |
* Total Harmonic Distortion is measured with a 6dB/octave filter @80kHz.
** Hum & Noise are measured with a 6dB/ octave filter @12.7kHz;equivalent to a 20kHz filter with infinite dB/octave attenuation.
| Power requirements |
Japan: |
AC100V 50/60Hz, 90W |
| North America: |
AC120V, 60Hz, 90W |
| Other Areas: |
AC220-240V, 50/60Hz, 90W |
| Dimensions (W x H x D) |
436 x 150 x 548 mm |
| Weight |
15kg |
Analog input characteristics
| Input terminal |
PAD |
GAIN |
Actual load impedance |
For use with nominal |
Input level |
Connector |
| Sensitivity |
Nominal |
Max. before clip |
CH INPUT
1 to 12 |
0 |
-60dB |
3kohms |
50-600ohm Mics & 600ohm Lines |
-70dB |
-60dB |
-40dB |
A:XLR-3-31 type (Balanced)
B:TRS phone jack (Balanced) |
| -16dB |
-26dB |
-16dB |
+4dB |
| 20 |
-6dB |
+4dB |
+24dB |
CH INPUT
13 to 16 |
-26dB |
10kohms |
600ohm Lines |
-36dB |
-26dB |
-6dB |
TRS phone jack (Balanced) |
| +4dB |
-6dBV |
+4dB |
+24dB |
| CH INSERT IN 1 to 12 |
10kohms |
600ohm Lines |
-6dB |
+4dB |
+24dB |
TRS phone jack (Unbalanced) |
| 2TR IN [L,R] |
10kohms |
600ohm Lines |
-10dB |
-10dB |
+10dB |
RCA pin jack (Unbalanced) |
Analog output characteristics
| Output terminal |
Actual source impedance |
For use with nominal |
Output level |
Connector |
| Nominal |
Max. before clip |
| STEREO OUT L,R |
150ohms |
600ohm Lines |
+4dB |
+24dB |
XLR-3-32 type (Balanced) |
| OMNI OUT 1 to 4 |
150ohms |
10kohm Lines |
+4dB |
+24dB |
TRS phone jack (Balanced) |
| MONITOR OUT L,R |
150ohms |
10kohm Lines |
+4dB |
+24dB |
TRS phone jack (Balanced) |
| CH INSERT OUT 1 to 12 |
600ohms |
10kohm Lines |
+4dB |
+24dB |
TRS phone jack (Unbalanced) |
| 2TR OUT [L,R] |
10Kohms |
600ohm Lines |
-10dBV |
+10dBV |
RCA pin jack (Unbalanced) |
| PHONES |
100ohms |
8ohm Lines |
4mW |
25mW |
ST phone jack (Unbalanced) |
| 40ohm Lines |
12mW |
75mW |
Digital input characteristics
| Terminal |
Format |
Data length |
Level |
Connector |
| 2TR IN DIGITAL |
IEC-60958 |
24bit |
0.5Vpp/75ohms |
RCA pin jack |
| ADAT IN |
ADAT *1 |
24bit |
- |
OPTICAL |
Digital output characteristics
| Terminal |
Format |
Data length |
Level |
Connector |
| 2TR OUT DIGITAL |
IEC-60958
Consumer use |
24bit |
0.5Vpp/75ohms |
RCA pin jack |
| ADAT OUT |
ADAT |
24bit |
- |
OPTICAL |
Control I/O characteristics
| Terminal |
Format |
Level |
Connector |
| TO HOST USB |
USB |
0V - 3.3V |
B type USB connector |
| MIDI |
IN *1 |
MIDI |
- |
DIN Connector 5P |
| OUT |
MIDI |
- |
DIN Connector 5P |
| THRU |
MIDI |
- |
DIN Connector 5P |
| WORD CLOCK |
IN |
- |
TTL/75ohms |
BNC Connector |
| OUT |
- |
TTL/75ohms |
BNC Connector |
*1. MIDI IN can use as TIME CODE IN MTC.
|
|
|